Abstract

To develop, maintain, and update orbital debris environmental and break-up models, such as the NASA Orbital Debris Engineering Model (ORDEM) and the NASA Standard Satellite Breakup Model (SSBM), the NASA Orbital Debris Program Office (ODPO) relies on the most recent validated datasets from various measurement sources, both laboratory and environmental. One key project that will provide insight for break-up events using modern-day spacecraft materials and construction techniques is the DebriSat laboratory hypervelocity-impact test. Based on the mass of the target, the projectile, and the impact velocity, the expected number of fragments greater than 2 mm, generated using the NASA SSBM, was estimated to be close to 85,000. To date, the DebriSat fragment database continues to grow, with over 200,000 fragments collected that will help inform updates to the SSBM. Additionally, the growing fragment ensemble will support key parameters for the next release of NASA's environmental models, employing fragment shapes, densities, and size distributions. To further support these environmental models, specifically the size parameter used in ground-based optical measurements, optical characterization on a subset of DebriSat fragments is being conducted in ODPO's Optical Measurement Center (OMC). Broadband bidirectional reflectance distribution (BRDF) measurements will provide insight into the optical-based NASA Size Estimation Model (OSEM). The OSEM equates an object's brightness to size (e.g., diameter of a disk or sphere) given several assumed parameters, including a defined phase function, albedo, and range. To address the first defined parameter, the ODPO has been using ray-tracing software to simulate light conditions in the OMC and to generate phase functions (i.e., specular, Lambertian, and experimentally derived) of known shapes, materials, and sizes. This simulated data, in addition to the experimentally derived measurements collected in the OMC, will aid in determining whether a new phase function would be suitable for an updated OSEM. The OSEM also assumes a single-value albedo, thus pre-impact spectral measurements on a subset of DebriSat materials were acquired for baseline material characterization and to provide insight into spacecraft material taxonomies. This DebriSat spectral data, along with spectral measurements from other known spacecraft material samples, will allow for better analyses of albedo variations and the effect on size calculations of defined laboratory targets, thus further supporting OSEM updates. This paper provides an overview of DebriSat, the status of the project, updates on the parameter distributions, an overview of the NASA SSBM, and ongoing fragment characterization efforts within the OMC.